Provide Power To Scan Tool - Bosch ADS 325 User Manual

en | 1 0 | User Manual | ADS 325

Provide Power to Scan Tool

ss02869
1
Scan Tool Cable Connections
1 . OBD II / DLC cable
2 . 12 volt power cable (Use with vehicles that do
not supply power through DLC)
3 . Scan tool
Power via vehicle DLC
1. Connect the OBD II / DLC cable to the scan tool
2. Connect the OBD II / DLC cable to the DLC on vehicle.
Located within 18 inches (45.7 cm) of steering wheel.
Typically located on the driver's side, under dash.
3. Turn ignition ON.
Non-powered vehicle DLC setup
Some vehicles do not supply power through DLC. In this case
use the following procedure.
1. Connect OBD II / DLC cable to scan tool.
2. Connect OBD II / DLC cable to DLC on vehicle. Typically
located on the driver's side under the dash.
3. Connect the 12 volt power cable to the scan tool power port.
4. Connect the 12 volt power connector to the vehicle power
outlet.
5. Turn ignition ON.
582819 | REV. A | 07.2018
ss02870
2
1
2
Scan Tool Connected to Vehicle
1 . OBDII/DLC Cable
2 . DLC
3 . Handset
Turning off handset:
ss02902
3
Connected
Main Menu
1. Press and release the power button.
ss02901
Connected
Main Menu
Select Vehicle
Power off
Diagnostic Tool will shut down.
Saved Diagnostic Data
System Settings
All Apps
2. Select OK. The tool will now shutdown.
10:22
May 16, 2018
Select Vehicle OBDII
Saved Diagnostic Data Web Browser
System Settings See What's New
All Apps
OBDII
Web Browser
CANCEL OK
See What's New
Bosch Automotive Service Solutions Inc
3
10:22
May 16, 2018