Table of Contents
Advertisement
3. MagicLAN Installation for Windows 95 (OSR2)/98
There are two types of WLAN Cards i.e. PCMCIA and PCI cards for Notebook and
Desktop PCs respectively. Here we explain the procedure of installing both cards under
Windows 95(OSR2)/98 operating system (OS) one by one. We will explain the installation
method for SWL-2100N PCMCIA adapter followed by the installation method for SWL-
2100P PCI adapter.
3.1 Installation Overview
Here are some steps you will perform in establishing your wireless network connection:
• Install the Access Point (SWL-2100AP) at first. AP is needed in case of
Infrastructure network mode.
• Install the software using the Installation CD.
• Now you should install the Wireless LAN Card (SWL-2100N or SWL-2100P).
• Install the network protocol(s) required to communicate on your network. Most likely
you will need the TCP/IP protocol.
3.2 Installation Procedure of SWL-2100N PCMCIA Card
Important: Do not insert the PCMCIA card until you are asked to do so, failure of
which may result in unsuccessful installation of your PCMCIA WLAN card.
Please follow the following steps one by one in order to install the PCMCIA card
successfully.
1. Power on your computer and allow Windows 95(OSR2)/98 to load fully.
2. Be sure that there is no PCMCIA adapter inserted yet.
3. Insert the given Installation CD in the CD-ROM. Select the Software Installation
from the menu and then click on the Install.
4. Accept the license agreement.
5. Give the path of the destination folder. To set the path of your choice click on Browse
and then click Next.
6. Select the type of card. As you are preparing to install the PCMCIA card, select the
PC CARD type and click on Next.
7. Select the ESSID. Default ESSID is ANY. You can change this later also using the
configuration utility or network configuration. Click on Next.
8. Select network type and click on Next. Default is Infrastructure.
11
Advertisement
Table of Contents
