Specifications - Sony HT-M2 Operating Instructions Manual

PROTECT
Irregular current is output to the speakers, or
the receiver is covered and ventilation holes
are blocked. The receiver will automatically
turn off after a few seconds. Remove the
object covering the upper panel of the
receiver, check the speaker connection, and
turn on the power again.
USB FAIL
An over current from the
was detected. The receiver will
automatically turn off after a few seconds.
Check the USB device, then unplug it and
turn on the power again.
Clearing the memory
Reference sections
To clear
All memorized settings
Customized sound fields

Specifications

Amplifier section
Power Output
Latin America and Argentina models
Stereo mode output (rated) (6 ohms, 1 kHz,
THD 1%)
Surround mode output
1 kHz, THD 30%)
FRONT:
SURROUND:
2)
Surround mode (reference) (6 ohms, 100 Hz,
THD 30%)
SUBWOOFER:
40
GB
(USB) port
See
page 19
page 31
1)
104 W + 104 W
2)
(reference) (6 ohms,
RMS output
1)
220 W per channel
1)
220 W per channel
1)
220 W per channel
South Africa model
Stereo mode output (rated) (6 ohms, 1 kHz,
THD 1%)
Surround mode output
1 kHz, THD 10%)
FRONT:
SURROUND:
2)
Surround mode (reference) (6 ohms, 100 Hz,
THD 10%)
SUBWOOFER:
1)
Measured under the following conditions:
Area
South Africa, Latin
America
Argentina
2)
Reference power output for front, surround
speakers and subwoofers. Depending on the sound
field settings and the source, there may be no
sound output.
Inputs
Analog
Digital (Coaxial) Impedance: 75 ohms
Outputs (Analog)
AUDIO OUT
Tone
Gain levels
Reproduction frequency range:
FM tuner section
Tuning range
Antenna (aerial)
Antenna (aerial) terminals
1)
104 W + 104 W
2)
(reference) (6 ohms,
RMS output
1)
165 W per channel
1)
165 W per channel
1)
170 W per channel
Power requirements
240 V AC, 50 Hz
230 V AC, 50 Hz
Sensitivity: 800 mV/
50 kilohms
Voltage: 800 mV/
1 kilohm
±6 dB, 1 dB step
28 Hz – 20,000 Hz
87.5 MHz – 108.0 MHz
FM wire antenna (aerial)
75 ohms, unbalanced