Trimming Beard; Cleaning The Trimmer - Panasonic ER206 Operating Instructions Manual

3
Slide the power switch upwards to
turn on the appliance.

Trimming Beard

Place the angled face of the comb against the
skin and cut the beard by moving the trimmer in
all directions to obtain a uniform cut.
With curly facial hair, the comb attachment may
not cut all of the hair. In this case, remove the
comb attachment and use a conventional comb to
draw out the remaining uncut hair.
When shaping the beard, remove the comb
attachment. Place the angled edge against the
skin and make the border of the beard even.
• Beard trimmings may collect inside the
attachment when a large volume of beard is cut,
so discard beard trimmings after each use.
10

Cleaning the trimmer

• Make sure that the trimmer is turned off.
• Clean the housing only with a soft cloth slightly dampened with
tap water or soapy tap water. Do not use thinner, benzine,
alcohol or other chemicals.
It is recommended to clean after every use.
1. Remove the trimmer from the AC adaptor.
2. Remove the comb attachment.
3. Hold the main body, place your thumb
against the blades and then push them
away from the main body.
4. Brush off any beard and
hair trimmings from the
main body and from around
the blade.
5. Brush any beard and hair trimmings
out from between the stationary blade
and the moving blade while pressing
down the cleaning lever to raise the
moving blade.
6. Apply the oil to the blade. (See page 11.)
7. Attach the comb attachment and
blades to the trimmer.