Page 1
Model No. ENGLISH FRANÇAIS Thank you for purchasing this Panasonic product. ■ Carefully read through these Operating Instructions and the operating instructions of the projector to ensure safe and proper operation. ■ Before using this product, be sure to read “Important Safety Notice” (page 3).
Dear Panasonic Customer: This instruction booklet provides all the necessary operating information that you might require. We hope it will help you to get the most performance out of new product, and that you will be pleased with your Panasonic Projector Frame.
Product description This frame is exclusively for the installation of dual projectors. ■ Structural components Parts name Form (number of parts) Frame × 1 Hexagonal head bolt with washers (M6 × 30) …………… × 6 Hex nuts (M10) ……………………………………………… × 8 Flat washers (M10) ………………………………………...
Projection distances The dimensional relationship between the screen and the projector is shown below. When planning the installation position of the projector, refer to the following figures and table for reference. The zoom function of the lens allows you to adjust the projection distance. Fine adjust while checking the projected image.
Installation Attaching the frame to the projector 1) Remove attachment plate from frame. Ú Remove the four hexagonal head bolts Hexagonal head with washers (M6 × 16) used to secure the bolt with washer attachment plate at the front and back. Remove the bolt (M6) and nut (M6) attached to the front, and remove the attachment plate from the frame.
Installation (continued) Attaching the upper level projector Another separate frame is required when stacking two frames together. Refer to [Attaching the frame to the projector] for the installation procedure of a frame and a projector. (page 6 ) 1) Check the strength and stability of the installation location.
Adjusting the upper projector Follow the steps below to adjust the angle of the upper projector so that the image projected on the screen matches that of the lower projector whereby the screen size, position, and focus is already adjusted to the screen. Only the angle of the upper projector is adjustable.