Usb Ports; Important Notes Concerning The Usb Ports - DeWalt DXAEPS2 Instruction Manual

1. Press the AC Power Button to turn on both 120V AC Power
Outlets. A beep will sound and the LCD Screen will display the
following:
The Battery Status Icon and the Wattage Indicator light solid; and
the Digital Display shows "0," indicating the dual AC outlets are
ready to use.
2. Insert the 120 volt AC plug from the appliance into one of the 120
volt AC outlets.
3. Switch on the appliance and operate as usual. The LCD Screen
will continuously display the following:
The Battery Status Icon and the Wattage Indicator light solid; and
the Digital Display shows the total output wattage of the dual AC
outlets.
NOTE: Ensure that the wattage of all equipment simultaneously
plugged into both 120V AC Power Outlets does not exceed 1000
watts continuous.
4. Press the AC Power Button again to turn off the 120V AC Power
Outlets.
DXAEPS2_ManualENSP_101216.indd 21
Monitor the unit's internal battery status on the LCD Screen. Four solid
bars in the battery icon indicates a full battery. When the battery level
is nearly empty with only one solid bar, the unit MUST be recharged
at this time.
Make sure the AC Power Outlets are turned off when the unit is being
recharged or stored.

USB Ports

The USB Power Button and the two USB Ports are located on the front
of the unit; the USB Power/Fault Indicator is a translucent ring around
each of the USB Ports. Refer to Fig. 2 to locate.

Important Notes Concerning the USB Ports

1. The two USB Ports provide a total of 3.1A (5V each).
2. When the USB Ports are in use, the unit will monitor for the following
USB fault conditions on all the USB Ports: thermal fault, low battery
voltage fault, overload and short circuit. If a fault condition exists in
either of the USB Ports, the USB Power/Fault Indicators will flash
blue. In any of these cases, the backlit LCD screen will continuously
display the following:
The Fault Icon will flash. The USB Ports will automatically shut
down. Should this occur:
a. Disconnect the USB-powered device and press the USB Power
Button again to turn off the USB Ports immediately.
b. Make sure the unit does not need to be recharged.
21
10/19/2016 3:56:35 PM