Analog detectors and bases
2.
3.
3.2
Locking and Releasing the Detector
The detector bases are supplied with a snap-off locking bar (X) as part of the base moulding
to prevent malicious removal of the detector. The locking mechanism is selectable and is
activated by shifting the U-shaped locking bar (X) into the position as shown.
1.
2.
3.
X
Figure 3.2: Activating the Locking Mechanism
4.
O
Figure 3.3: Releasing the Detector
Bosch Security Systems, Inc.
Tighten the base to the mounting surface. Do not over tighten. If you use a 6-inch base, fit
the base skirt onto the mounting base.
Turn clockwise until the detector head locks into place and aligns with the semi-circle
notch (4).
Remove the U-shaped locking bar by breaking it from its holder.
Tuck it into the opening next to it by pushing hard.
Insert the detector head into the base.
Release the locked detector head by pushing hard through the dimple (O) on the
detector's outer rim with a screwdriver and at the same time, turning the detector head
to the left.
X
Installation Guide
Mounting | en
7
O
2018.08 | 6.0 | F.01U.123.589