Install A Power Module; Fan Removal And Installation; Remove A Fan - Huawei Quidway Eudemon 200 Installation Manual

Hide thumbs Also See for Quidway Eudemon 200:

Table of Contents

Installation Manual

Quidway Eudemon 200 Firewall

Caution:

If no power module has been installed in the slot, install the blank filler panel to keep air going and heat

dissipation and prevent dust entering.

Figure 5-1 Power module removal

5.2.2 Install a Power Module

Step 1: Hold the handle of the power module panel, slowly push the module into the

chassis along the guides until it well touches the rear power panel inside the power slot

of the chassis.

Step 2: Fasten the two captive screws in the power module panel.

Step 3: Check if the power switch on the panel is ON.

Step 4: Plug one end of the power cord shipped with the chassis into the socket in the

power module and connect the other end to the power supply.

Step 5: Check if the power status indicator on the RPU is normal. For specific

meanings, see "1.4.1 RPU".

The fan is hot-swappable and used for exhausting air to cool the cards. The fan is

installed vertically to the right side inside the integrated chassis.

Figure 5-2 shows how to remove a fan module.

Chapter 5 Hardware MaintenanceHardware

5-2

Maintenance

Table of Contents

Show Quick Links

Table of Contents