Figure 5 Routing The Data/Power Cable To The Router; Table 6 Ethernet Pin Assignments (Port 1) - ABB MicrOS 410 Installation Manual

Connecting the Ethernet cable
Have the Ethernet data cable, nut, rubber boots, and cable gland available.
1.
Remove the cable gland from the bottom of the MicrOS 410. For power and Ethernet
2.
connectivity, use Port 1.
3. Press the tab on the RJ45 connector down as you push the cable through the nut. Make sure
that the orientation is consistent with
Separate the rubber boot as needed and slide the connector through the boot. Use the boot
4.
with the smaller diameter opening, unless the cable is too wide to permit the boot to close
completely. Use only one boot.
Slide the cable through the cable gland, as shown in
5.
Figure 5
Table 6
Pin
1
2
3
4
5
6
7
8
Port 2 has the same pin assignments as port 1 except that power is not supported on Port 2, so
pins 4, 5, 7 and 8 are not used.
MicrOS 410 Installation Guide
Routing the Data/Power Cable to the Router
Ethernet Pin Assignments (Port 1)
Assignment
TX+
TX-
RX+
Power+
Power+
RX-
Power-
Power-
Figure .
Figure .
Chapter 2
23