Making The Ptp 300/500/600 Series Bridge Pidu Plus Connection At The Odu; Connecting The Pidu+ To The Odu - Motorola PTP 300 Series User Manual

Motowi4 series

Hide thumbs Also See for PTP 300 Series:

Table of Contents

Installation

7.7.3 Making the PTP 300/500/600 Series Bridge PIDU Plus Connection At The ODU

The following procedure describes how connection is made at the ODU. It is often easier to carry

out this procedure on the ground or a suitable surface prior to mounting the ODU.

Ensure that no power is connected to the PIDU Plus or present on the cable before connecting the

ODU.

Step 1: Assemble the cable

Step 2: Insert the RJ45 connector making

as described in 5.7.1 above

sure that the locking tab snaps home

Step 3: Screw in the body of the

Step 4: Screw on the clamping nut and tighten

weather prooﬁng gland and tighten

(Do not over tighten – see

Figure

20)

Figure 19 Connecting the PIDU+ to the ODU

CAUTION: Do not over tighten the glands as the internal seal and structure may be damaged.

See

Figure 20

for an example of an over tightened cable gland.

Table of Contents