Table of Contents
Advertisement
Installation
After checking the height, width, and structure of the installation location, determine the appropriate positions for
setting up the screen and installing the projector.
Setting up the screen
Set up the screen according to the specified method in a position which takes into account the projection distance
and angle and the type of screen being used.
Screws tightening torques
M6 ......... 4±0.5 N•m
M8 ......... 10±1 N•m
M10 ....... 20±1 N•m
z Use a torque screwdriver or torque wrench to tighten screws and bolts to their specified tightening torques. Do
not use electric screwdrivers or impact screwdrivers.
Preparing the attachment plate
Before installing the attachment plate on the ceiling, attach the adjustment poles, pole braces, and the pole base
to the attachment plate with the following procedures.
■ Attaching the pole brace 1 and the adjustment pole 1 to the attachment plate
Arrow
To the screen
(Front)
Pole brace 1
M6 Hex nuts
M6 Flat washers
(M6 × 16)
■ Attaching the pole brace 2 and the pole base to the adjustment pole 2
Adjustment pole 2
Pole brace 2
6 - ENGLISH
(M6 × 16)
Attachment plate
Adjustment pole 1
"FRONT"
inscription
Pole base
"FRONT"
inscription
1) Insert the pole brace 1 into the center of the
attachment plate, and secure the pole brace 1 with
the supplied six captive washer hex head bolts (M6 ×
16). (Refer to the figure on the left for the directions of
the attachment plate and the pole brace 1.)
2) Insert the adjustment pole 1 into the pole brace 1,
aligning them so that the "FRONT" inscription faces
the front.
3) Insert the supplied two captive washer hex head
bolts (M6×80) through the side of the pole brace 1,
and secure them with M6 hex head nuts and M6 flat
washers. Attach the supplied two captive washer
(M6 × 80)
hex head bolts (M6 × 16) from the screen side of the
pole brace 1, and secure the pole brace 1 and the
adjustment pole 1.
Attention
z Be sure to tighten the screws and bolts to their
specified tightening torques. Insufficient tightening
torque may cause the projection screen to tilt.
1) Temporarily secure the pole brace 2 to the adjustment
pole 2 using the supplied three captive washer hex
head bolts (M6 × 16), and secure them firmly.
2) Insert the adjustment pole 2 into the hole of the pole
base, aligning the "FRONT" inscriptions as illustrated
on the left, and secure them with the supplied three
captive washer hex head bolts (M6 × 16).
Hide quick links:
Advertisement
Table of Contents
