Electrolux EDS Installation Manual page 12

12
Connect the cable from the J2 port on the EDS controller to the RS232 port on the I/O module.
Strap the cable at suitable positions.
Connection to I/O module type 1, 11 or 3
Disconnect the power to the machine.
Remove one of the covers to the holes on the back of the machine. The location is different on different models.
The cable from the J2 port on the EDS controller shall then be run through the hole (A) and connected to the RS232
port on the I/O module.
Insert the cable and mount with the counter nut and cable gland according to the figure.
Installation manual
fig.W01145
fig.W01146