Advertisement
Important: If a message or dialog box appears on the screen, follow the
on-screen prompts to complete the driver installation.
Linking the mouse and receiver
The mouse has 256 identification codes that allow the mouse and its
receiver to operate without interference from other RF devices. After
your computer detects the USB receiver and then default driver is
installed, you must make a communications link between the mouse
and its receiver before you can use the mouse.
- Communications link is as the below steps :
.
Press and release the link button on the receiver. The receiver
lights first blinks in green when the receiver is activated, and then
turn off.
2.
Press and release the link button on the bottom of the mouse. The
two devices establish their communication link. The receiver lights
first blinks in green, and per mouse motions could be detectable
and reflected as well as green blinks.
Button Switch
.
Press and hold both buttons for 3 seconds, then release buttons.
3
English
Advertisement
