Husqvarna CG 200 Operator's Manual page 9

2. The motor stops if operator presence control handle
(1) is released.
3. Check regularly that it operates correctly. Do not lock
it in position.
To start the fuel product
1. To start the motor, see the motor manufacturer
manual.
2. Let the motor warm up.
To start the electric product
1. To start the product, push the motor start switch to
ON(I).
130 - 003 - 18.08.2017
To stop the product
1. To stop the product, release the operator presence
control handle (1).
To choose a cutting head
Different cutting heads can be applied to different
situations. There are mainly three cutting heads you can
choose to use, the star cutting head, the beam cutting
head, and the carbide cutting head.
• Use the star cutting head to clean or remove the
epoxy paint, oil and glazes, glue, thermo plastic road
marking.
• The beam cutting head can be used for light
preparation of asphalt and concrete, for cleaning out
antiskid grooving such as on ramps, for descaling
steel and the cleaning of roads ready for line
marking.
• Use the carbide cutting head to texture the asphalt
and concrete.
To mill the concrete
Note: Cutting depth is maximum 3 mm (1/8"), for deeper
cuts make several passes.
1. Pass the product over several times according to the
nature of the concrete.
2. Check the concrete and stop milling if the desired
result is obtained.
To adjust the cutting depth
The cutting depth can be adjusted depending on the
need.
9