Canon CX-G6400 User Manual page 182

Chapter 6 Troubleshooting
Error Message
Stacker overloaded
Stacker inspection
Paper retention X
("X" represents number)
Feed error 1
Feed error 2
Thick feed lever position
error 1
Thick feed lever position
error 2
178
Error Content
Paper ejected to the auto
stacker has exceeded the
upper limit.
Paper is jammed in the auto
stacker.
Paper still remains after removal
of jammed paper.
The paper is not fed.
Or there is paper dust stuck to
the pick-up roller.
Paper has been pulled out of
the feeder tray during printing.
The thick feed lever position is
not correct.
The thick feed lever position is
not correct.
Handling
Remove the ejected paper.
Remove the ejected paper.
Open the upper unit and check
the transport area.
（→
Reload a paper. P.15
（→
Check to make sure the printer
driver paper type settings are
correct. P.46
（→ ）
*When using a custom paper size
P.50
（→ ）
If the same error occurs again,
there could be paper dust stuck
to the pick-up roller. Clean the
pick-up rollor. P.157
（→
Do not pull out paper during
printing. If it is absolutely
necessary to pull out paper
during printing, press the PAUSE
key on the operation panel to
stop printing temporarily, and
then pull out paper.
When using special heavy paper
or plastic card, pull the thick
paper transport lever.
（→
When using other than special
heavy paper or plastic card, push
in the thick paper transport lever
original position. P.25
（→
P.173
）
）
）
P.25
）
）