Faults / Troubleshooting - Siemens FT2011 Operation Manual

8 Faults / Troubleshooting

'Fault'
'Automatic detector'
'Manual call point'
'Mains failure'
Building Technologies
Fire Safety
If the ↑ 'Site' displays a 'Fault', the table below provides a list of all possible
'Faults', including information on the possible causes.
If a 'Fault' cannot be eliminated with the help of these operation instructions, please
contact the service engineer.
Cause
'Detector' missing
'Detector' defective
Glass pane broken
Other damages
'Mains failure' in the
public network
Fuse damaged
With all other 'Faults', the service provider in account must be contacted.
Remedy
Re-insert 'Detector'
Replace 'Detector' with replacement detector.
CAUTION! Any defective 'Detector' must always be
replaced by a 'Detector' of the same type.
Replace glass pane
Contact service provider
No action required.
Emergency power supply is ensured by batteries during
at minimum 12 hours; depending on the customer
specification up to 72 hours.
Check fuses (current distributor of the building) and
replace them if necessary.
Faults / Troubleshooting
009311_k_en_--
2015-12-15
8
27 | 32