Kenwood TS-890S Command Reference Manual page 56

QA
Quick Memory Channel Information
1 2 3
Read
Q A P1
1 2 3
Q A P1
11 12 13
Answer
P2 P2 P2
21 22 23
P4 P4 P4
QD
Quick Memory Channel All Delete
1 2 3
Set
Q D ;
1 2 3
Answer
Q D ;
QI
Writing Quick Memory Channel
1 2 3
Set
Q I ;
1 2 3
Answer
Q I ;
QR
Quick Memory Channel ON/OFF
1 2 3
Set
Q R P1
1 2 3
Read
Q R ;
1 2 3
Answer
Q R P1
PC Control Command referenCe guide
4 5 6 7 8
;
4 5 6 7 8
P2 P2 P2 P2 P2
14 15 16 17 18
P2 P3 P4 P4 P4
24 25 26 27 28
P4 P4 P4 P5 P6
4 5 6 7 8
4 5 6 7 8
4 5 6 7 8
4 5 6 7 8
4 5 6 7 8
P2 ;
4 5 6 7 8
4 5 6 7 8
P2 ;
Parameters:
P1 (Quick Memory Channel Number)
9 10
0 ~ 9
P2 (Frequency Information on left side VFO (11-digit))
Unused high-end digits will become 0.
9 10
 When no information is available for a parameter, it is
P2 P2 returned as blank.
P3 (Mode Information on left side VFO)
19 20
Refer to the P2 value of the OM command.
P4 P4
 When no information is available for a parameter, it is
returned as blank.)
29 30
P4 (Frequency Information on right side VFO (11-digit))
;
Unused high-end digits will become 0.
 When no information is available for a parameter, it is
returned as blank.)
P5 (Mode Information on right side VFO)
Refer to the P2 value of the OM command.
 When no information is available for a parameter, it is
returned as blank.)
P6 (Simplex Information)
0: Simplex
1: Split
 When no information is available for a parameter, it is
returned as blank.)
• This command will not automatically respond when using the AI
function.
Parameters:
No parameters are used with this command.
9 10
• When the AI function is ON, a response is output when all
deleting the Quick Memory Channel.
9 10
• You cannot perform this command when Quick Memory Channel
mode is OFF.
Parameters:
No parameters are used with this command.
9 10
• Performs the same function as pressing [Q-M.IN].
• When the AI function is ON, a response is output when writing
9 10
to the Quick Memory Channel.
Parameters:
P1 (State)
9 10
0: Quick Memory Channel OFF
1: Quick Memory Channel ON
P2 (Channel number)
9 10
0 ~ 9
 If parameter P1=0, set parameter P2 to 0.
 When selecting Quick Memory Channel ON but not setting a
9 10
channel number, this setting is space.
• When configuring a value above the number of Quick Memory
Channel channels set by the menu, an error occurs.
• When specifying a blank channel, an error occurs.
– 55 –