Chapter 2 Preparations
1.10
Jumper Settings and Cable Connections Based on Internal
Hard Disk Drive Configuration
This section describes the jumper settings and cable connections when using hard disk drives installed in HDD
cages in a non-RAID System or RAID System.
Set the jumper on the motherboard according to your system, as shown below.
Important
If you use hard disk drives in the RAID system or change the RAID level,
initialize the hard disk drives. If the hard disk drive contains valuable data, be
sure to backup the hard disk drive before installing the RAID controller and
configuring the RAID system.
Note
In the RAID system, use hard disk drives that have the same specifications
(capacity, rotational speed, and standard) for each disk array.
Tips
Logical drives can be created even with only one physical device.
Important
Avoid static electricity to work with the procedure below. For details, see
Chapter 2 (1.2 Anti-static Measures).
Express5800/R110f-1E User's Guide
1. Installing Internal Optional Devices
61