Noise Blanker - Kenwood TS-890S Instruction Manual

2 NAMES AND FUNCTIONS OF PARTS
Area Display
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
2-10
Appears when the RIT function is enabled.
Appears when the XIT function is enabled.
Displays the RIT or XIT frequency (between -9.999 and 9.999 kHz).
Appears according to the input path of the TX audio selected by the data VOX function.
OFF: Appears when sound is not input from all paths.
ACC 2: Appears when ACC 2 is used as the audio source input.
USB: Appears when USB AUDIO is used as the audio source input.
LAN: Appears when LAN is used as the audio source input.
Displays the microphone gain. (Displayed when the speech processor is OFF)
Displays the speech processor output level. (Displayed when the speech processor is ON)
Displays the VOX delay time when the transmitting end is in the SSB, AM or FM mode.
Displays the break-in delay time when the transmitting end is in the CW mode.
"FULL-BK" is displayed during full break-in.
This is an icon of the internal memory. The icon is displayed in red when the remaining space is
running low.
The icon starts to blink when a USB flash drive is connected, and lights up when the USB flash drive
is recognized by this transceiver.
The icon is displayed in red when the remaining space is running low.
Appears when the timer function is enabled.
Appears when a KNS user is connected to this transceiver.
Displays the selected RX filter (A, B or C).
Displays the low-cut frequency of the RX filter.
Displays the width frequency of the RX filter.
Displays the bandwidth of the RX filter.
Displays the low-cut frequency of the RX filter.
Displays the shift frequency of the RX filter.
Displays the position of the notch frequency when the notch filter is ON.
Displays the passband/audio FFT.
Displays the audio FFT spectrum of the RX or TX audio.
Displays the center indicator.
• Indicates the pitch frequency when in the CW mode.
• Indicates the center frequency of the passband when in the FSK or PSK mode.
• Indicates the center frequency of the horizontal axis that is currently displayed when in the SSB,
FM or AM mode.
Displays the selected bandwidth for the roofing filter.
Meter display
• This can be switched to an analog or digital display.
• Display of the information on the TX meter can be switched when an analog meter is displayed.
Appears when the auto mode is ON.
Appears when Noise Reduction 1 (NR1) is ON.
Appears when Noise Reduction 2 (NR2) is ON.
Appears when Noise Blanker 1 (NB1) is ON.
Appears when Noise Blanker 2 (NB2) is ON.
Appears when both Noise Blanker 1 and 2 are ON.
Appears when Beat Canceler 1 (BC1) is ON.
Appears when Beat Canceler 2 (BC2) is ON.
Appears when the notch filter is ON and "Wide" is selected for the bandwidth.
Appears when the notch filter is ON and "Middle" is selected for the bandwidth.
Appears when the notch filter is ON and "Narrow" is selected for the bandwidth.
Appears during split operation.
Description
Refer
to
5-7
8-1
4-7
8-4
5-8
11-1
14-3
15-2
6-1
6-3
6-6
6-1
8-4
5-9
5-17
5-22
6-2
4-9
4-4
6-7
6-5
6-8
6-6
5-1