Front View, Operating Elements And Connections; Lcd; Blue Function Button; 3 Min./Max. Button - Bosch MMD 302 Original Instructions Manual

3.5 Front View, operating elements and
connections
1
REL H MAX MIN
MEM
mVA
DC
C n u F
MK Hz
AC
MIN MAX REL HOLD
2 3 4
PRW RST MIN MAX
7
6
ADPHz
4mA
40mA
V
8
V
OFF
COM
A mA
9
10 11
MAX
MAX
MAX
10 A cont.
400mA
20 A 30sec. CAT.III 600V
FUSED
FUSED
456163-01_Ko
Fig. 1: Front view MMD 302

1 LCD

2 Blue function button

3 MIN./MAX. button

4 REL - button
5 HOLD-button
6 PWR RST button
7 RANGE button
8 Measuring-mode switch
9 Test input for the 10A measuring range
10 Test input for the mA measuring ranges
11 Earth input, used for all measuring modes
12 Test input for alternating voltage, direct voltage, continuity test,
resistance measurement, capacitance measure- ment, diode
testing, frequency measurement
Robert Bosch GmbH
H
5
400
mA
A
V
Hz
12
General Information | MMD 302 | 19
3.5.1 LCD
Consisting of:
R
Analog display (42 segments), displays the current
measured value
R
Digital display (display range, 3999), the display
of the measured value depends on the selected
measurement mode (selected by means of measure-
ment-mode switch and function button)
3.5.2 Blue function button
Depending on the position of the measurement-mode
switch, pressing this function button switches between:
R
Continuity test and resistance measure- ment
R
Capacitance measurement and diode test
R
Frequency measurement
R
Direct and alternating current measurement
3.5.3 MIN MAX button
R
The minimum memory is activated by pressing the
button once (the smallest measured value is saved
and displayed).
R
The maximum memory is activated by pressing the
button again or twice (the greatest measured value
is saved and displayed). The MIN/MA measured val-
ues appear in the digital display.
R
The appearance of MIN or MAX symbols on the LCD
indicates whether the minimum or maximum memo-
ry respectively has been activated.
R
The analog display always indicates the current
measured value.
R
Measurement is "frozen" by pressing the HOLD but-
ton (fig. 1, pos. 5). Measurement resumes by press-
ing the button again.
R
You leave the MIN./MAX. mode by pressing the
RANGE-button (fig. 1, pos. 7) for approx. 2 seconds.
3.5.4 REL ∆-button
R
By pressing the button once, the current measured
value is saved and the digital display is set to 0000.
REL appears in the display. The value now displayed
represents the differential between the measured
and saved values.
R
The analog display always shows the current mea-
sured value.
R
You can exit the REL -∆ mode by pressing the RANGE-
button (fig. 1, pos. 7) for approx. 2 seconds.
en
|
1 689 979 642 2014-11-03