Cisco D9887B Installation And Configuration Manual page 75

4 Use the Left and Right buttons to select the column to edit and use the Up and
Down buttons to change the vertical step (-50 – +50 steps, where the minus
direction moves the video to the left), then press the Enter button to save the
selection.
SDI VANC Assignment
To edit the SDI VANC Assignment, use the following steps.
1 Use the Up and Down buttons to move the cursor to "SDI VANC Assign," then
press the Enter button to display the status screen for the VANC.
2 Press the Enter button once more to enter the Edit screen.
Ancillary Data Packets
This controls the embedding to the Ancillary Data Packets (ADP) into the VANC of
the SDI output.
1 Use the Up and Down buttons to move the cursor to the desired type of
Ancillary Data Packet ("EIA-608CC", "EIA-708CC", "TTX S2031M", "Source ID",
or "SCTE 127", "AFD"), then press the Enter button.
2 Use the Up and Down buttons to choose "Enabled" or "Disabled," then press the
Enter button to save the selection.
3 Use the Up and Down buttons to select "Line" for the ADP and press the Enter
button.
4 Use the Up and Down buttons to change the line number (4 – 15) in which the
ancillary data will be located.
Note: Repeat steps 1-4 above to change EIA-708CC, TTX S2031M, Source ID,
SCTE-127 and AFD.
78-4043743-01 Rev A
Dual Video Output (2 SDI, 1 RGBHV/YPbPr/Composite) Option
51