1
Installing the Steering Wheel
Parts needed for this procedure:
1
Steering wheel
1
Foam collar
1
Washer
1
Locknut
1
Steering-wheel cover
Procedure
1. Move the front wheel so that it points straight ahead.
2. Slide the foam collar, small end first, onto the steering
shaft
(Figure
2).
1. Foam collar
2. Steering wheel
3. Washer
3. Slide the steering wheel onto the steering shaft
2).
4. Secure the steering wheel to the steering shaft with a
washer and a locknut
5. Torque the locknut to 27–35 N-m (20–26 ft-lb).
6. Press the steering-wheel cover into position on the
steering wheel
(Figure
Figure 2
4. Nut
5. Steering-wheel cover
(Figure
2).
2).
2
Removing the Battery
No Parts Required
Procedure
Remove the 2 wing nuts and washers securing the top battery
hold-down to the side battery hold-downs
the top battery hold-down and remove the battery.
1. Battery
2. Positive (+) battery
terminal
(Figure
10
(Figure
3). Remove
Figure 3
3. Negative (-) battery
terminal
4. Top battery hold-down