Point Programming For 6815 Module - Honeywell 6820EVS Installation And Optimization Manual

LS10144-001SK-E
Type
Function
Selection
INTERLOCK
STATUS POINT
EVS INPUT
EVS TAMPER
SWITCH
(cont.)
EVS SUPER-
VISORY
CO DETECT SW
CO
SUPERVISORY
DETECT SW
OUTPUT PT
AUX CONST
AUX RESET
NOTIF
AUX DOOR
OUTPUT PT
AUX RESET
RELAY
AUX DOOR
LED NUMBER
SLC LED LED FUNCTION
9.5.2

Point Programming For 6815 Module

To program for points on an 6815 module, follow these steps:
1. Enter the installer code. The panel will automatically go to the main menu.
2. Select 7 for Panel Programming.
3. Press 4 to enter point menu.
4. Press the up or down arrow key to select the desired module. Refer to Section 8.5 Quick Reference Table for
available choices. Then press ENTER.
5. Select S for sensor or M for module. (SK Only)
6. Enter the number of the point you wish to edit, then press ENTER.
Table 9-3: Programming Options for 5815XL Modules
Latching Option
Latching
Non Latching
Latching
Non Latching
Latching
Non Latching
Select Group
Select Group
01-80
Unused
NOTIF
Comments
Interlock release switch input.
User also has EVS Event Number 1-8 option for EVS INPUT.
Only available when an EVS-VCM is installed in the system.
CO Detector Switch
CO Supervisory Detector Switch
Output point, a general use notification type. Use for driving
standard notification appliances.
Use constant power for applications that require a constant auxiliary
power source. Power is always present at constant circuits.
Use for auxiliary power, resettable applications. See Section 4.16.3
for a description of how this option operates.
Use for auxiliary power, door holder applications. For example, if
you were using an auxiliary power supply for door holders, you
would use this option. See Section 4.16.3 for a description of how
this option operates.
Output point, a general use relay type. Use for applications requiring
a relay, such as fan shutdown, elevator recall, and so on.
Use for auxiliary power, resettable applications. See Section 4.16.3
for a description of how this option operates.
Use for auxiliary power, door holder applications. For example, if
you were using an auxiliary power supply for door holders, you
would use this option. See Section 4.16.3 for a description of how
this option operates.
For use with SD devices only. 80 sub addresses on LED.
Notification can have group number.
9-12
Programming