Connecting A Pgx1 - Yamaha PGM1 Installation Manual

Connecting a PGX1

Up to two PGX1 units can be connected to one PGM1 unit.
NOTICE
• Before making connections, detach the Ethernet cable and gooseneck mic.
• Make sure to place a soft cloth underneath the device so that the surface of the body will not be
damaged.
1.
Turn the PGM1 and PGX1 units over on their back.
2.
Place the PGM1 on the right, and place the PGX1 to be connected on the left.
3.
Remove the rubber cap from the bottom panel of the PGM1.
4.
Use the included connection cable to connect the PGM1 and PGX1.
5.
Place the connecting bracket between the two units, and fasten the screws (at the 8
locations shown below) on the PGX1 side to secure it.
PGX1
6.
Place the rubber cap that you removed from PGM1 into the socket of the unused
dedicated 8-pin connector of the PGX1.
If you want to connect a second PGX1 unit, you can do so in a similar way.
16 PGM1/PGX1 Installation Manual
PGX1
Connecting bracket
PGM1
PGM1
Connecting bracket