Installation Procedure; Base Unit Installation - Philips Antumbra Installation Manual

2.2

Installation Procedure

The following installation procedure applies to all Antumbra panel variants.
Antumbra panels are powered from the DyNet network, which is classified as SELV/Class II
(for NA) Overvoltage category III in accordance with IEC60664-1(0.8 kV surge).
Ensure that installation of the Antumbra Panel is in compliance with HD 60364 - 4I where
applicable.
Caution: Use approved DyNet power supplies only with incorporated overload protection.
Disconnect DyNet before attaching the communication module to the application module.
2.2.1

Base Unit Installation

The communication module and application module lock in together when the locating pin
on the Application module lines up with the locating socket on the communication module
(circled below).
Antumbra 17
13 October, 2017
Installation