Advertisement
Installation
1.
Determine the optimal location of the RSX and
antenna for RF communications.
Ideally, the antenna should extend below the
terminal box.
2.
Mount the RSX using the provided screws.
3M
TM
Scotchlok
Power Connectors (Typical of 2)
TEC
Power Wire
1. Thread TEC power
wire through
connector.
2. Fold up flap to
lock TEC wire
into connector.
3. Insert power wire
from RSX into
connector so it
appears in window.
4. Use lineman's
pliers to pinch
connecting bar in
place and connect
wires internally.
5. Close connector
cover to secure
wires.
Siemens Industry, Inc.
TM
TEC Power
(From Transformer)
RSX
Power Wire
24 Vac
Power Line
Ground
Figure 4. RSX Communication and Power Wiring.
3.
Connect the RTS communication port of the
TEC device to the RSX (Figure 4). The
maximum cable length is 100 ft (30 m).
NOTE: If you do not have the proper cable to
connect the TEC device to the RSX in
step 3, Table 1 on page 4 provides pin
connections to make your own cable.
4.
Connect to 24 Vac power (Figure 4).
a. Connect "H" and "N" on the RSX power
connector to the TEC power source as
shown.
b. Connect "E" on the RSX power connector
to earth ground as shown.
TEC
(Typical)
24 V-AC
DO 1 DO 2 DO 3 DO 4 DO 5
DO 6 DI 3 DI 2
NO C NO C NO C NO C NO C
NO C AI 3
E
C
H
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
C H
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
Document No. 563-067
Installation Instructions
February 23, 2011
FLN
TRUNK
TX RX +
-
S
BST
RTS
RSX/TEC
Connection
Cable
Alternate
Power
Page 3 of 5
Advertisement
