Rear Panel - Panasonic AW-HR140PJ Operating Instructions Manual

AW-RP50 (not supplied) (continued)

Rear panel

„ „

 POWER switch [POWER]
When the POWER switch is set to the ON position, the POWER
indicator (1) lights, and the unit can be operated.
 TO PAN/TILT HEAD 1 to 5 connectors
[TO PAN/TILT HEAD 1 to 5] (RJ-45)
Connect the remote cameras to these connectors using straight
cables (category 5 or above).
 LAN connector [LAN] (RJ-45)
(10BASE-T/100BASE-TX)
Connect the remote camera, switcher or host computer that supports
IP connections to this connector using a LAN cable.
When directly connecting a device to the AW-RP50, use a crossover
cable (category 5 or above).
When making the connection through a hub (switching hub) or other
device, use a straight cable (category 5 or above).
 TALLY/GPI input/output connector [TALLY/GPI]
(D-sub 15-pin, female, inch thread)
 DC IN socket [12V IN] (DC 12 V)
The AC adaptor provided with the unit is connected to this socket.
 Ground terminal [SIGNAL GND]
Connect this to the system's ground.
 SERVICE switch [SV/NM]
This switch is used for maintenance purposes.
Normally, it is set at the "NM" position.
 Wire fastening fitting
An anti-theft wire available on the market can be fastened to this
fitting to prevent theft.

SIGNAL GND
TO PAN/TILT HEAD
TALLY/GPI 5 4 3


POWER
ON
12V IN
2 1 LAN
BOOT
SV NM
 
Operating Instructions


39