Yamaha PW45 Original Instructions Manual page 27

BATTERY PACK AND CHARGING PROCEDURE
S-Pede Kit Manual (2016).indd 24
TIP
• Charging will start automatically.
• If the display unit is turned on while the battery pack is
charging, all normal displays will be shown, including
the battery capacity indicator, but the assist system will
not function.
• When the battery pack is connected to the battery
charger, battery charger lamp will flash at approximate-
ly 0.2 second intervals to indicate that charging is pre-
paring to charge the battery pack. Leave it as it is and
charging will start normally.
[CHARGING THE BATTERY PACK REMOvED FROM
THE BICYCLE]
1. Turn the display unit off.
2. Insert the key into the battery lock, and turn it clockwise
to release the battery lock.
3. Remove the battery pack.
WARNING
Use both hands when removing the battery pack, be-
ing careful not to drop it. Dropping the battery pack
on your foot could result in injury.
4. Connect the power plug of the battery charger to a
household power outlet.
5. Remove the cap from the charging connector on the
battery pack, and connect it to the charging plug on the
battery charger.
NOTICE
• Do not connect the charging plug of the battery
charger with the charging connector of the battery
in a wet state.
• Be sure to connect the charging plug only after the
charging connector on the battery pack is com-
pletely dry.
Otherwise the battery charger and battery may mal-
function.
• Do not apply excessive force to the charging plug
or pull on the cord with the charging plug connect-
ed to the battery.
Otherwise, the plug or connector may be damaged.
24
2015/06/24 9:22:12