INSTALLATION INSTALLATION Installation Parts and Tools Parts not Provided Electrical cable Water supply tube Fittings for tube Coupler Teflon™ tape Air gap Wire nuts for Hose clamp ⅞" UL approved Electrical tape 16-gauge wiring strain relief Tools Needed Flat-blade Phillips Hole saw Electrical drill Gloves...
12 INSTALLATION Installation Overview Preparing Cabinet Opening Leveling the Dishwasher Preparing Electrical Wiring Securing the Dishwasher to Countertop Preparing Water Supply Connection Connecting the Drain Hose Preparing the Dishwasher Connecting Water Supply Removing Lower Cover Connecting Power Sliding the Dishwasher into Cabinet Final Check Product Dimensions Back view...
INSTALLATION Preparing Cabinet Opening WARNING This dishwasher is designed to fit a standard dishwasher opening. An opening may be needed • Don't use existing holes unless they are in the on both sides to route plumbing and electrical target area. Otherwise, the water supply and connections.
14 INSTALLATION Preparing Electrical Wiring Preparing Water Supply Connection Operate this appliance with the correct voltage as shown in this manual and on the rating plate. Make sure the house water supply is turned off Connect it to a dedicated, properly grounded before connecting the dishwasher water lines.
Page 6
INSTALLATION Preparing Dishwasher Removing Lower Cover Remove the two screws attaching the lower Removable Rear Plastic Shipping cover to the dishwasher. Brace Remove the lower cover from the base. The rear shipping brace can be removed if additional clearance is needed when installing the dishwasher under a low countertop.
16 INSTALLATION Sliding Dishwasher into Attaching Mounting Hardware Cabinet For countertops made of wood or other material that will not be damaged by drilling, use the metal installation brackets. Slide the dishwasher carefully into the cabinet opening. Insert the installation brackets into the slots in the upper frame.
Page 8
INSTALLATION Leveling the Appliance Adjusting the Legs Adjusting the Front Legs Check that dishwasher is level. • Use a flat-blade screwdriver or a pliers to turn the • Attach level on top front opening of tub from side to side. front legs and adjust the front of the tub.
18 INSTALLATION Securing Dishwasher to Connecting Drain Hose Countertop For countertops made of wood or other material that will not be damaged by drilling, use Method 1. For countertops made of granite, marble, or other materials that could be damaged by drilling, use 40"...
Page 10
INSTALLATION Connecting to Disposal or Waste Tee NOTE • If the knockout plug has not been removed, the with Air Gap dishwasher will not be able to drain properly. Remove the knockout plug with a hammer and screwdriver. Connecting to Disposal with No Air Connect end of the drain hose to the air gap with hose clamp provided.
20 INSTALLATION Connecting Water Supply Connecting Power Before connecting, turn off the water supply. Slide the flexible stainless-steel water line or copper tube into the elbow. Tighten the compression nut and make sure that the line is not kinked or pinched. NOTE •...
Page 12
INSTALLATION Final Check Error Code Possible Cause and Solution Drain hose kinked or pinched. Turn on electrical power. Feed the drainage and supply Turn on house water supply. hoses through the hole under the sink. Then gradually slide the dishwasher into the cabinet while Make sure the door opens and closes smoothly.