Mounting The Thin Client - HP t620 PLUS Hardware Reference Manual

Mounting the thin client

HP t620 Thin Client: HP recommends mounting the thin client in the vertical (tower) orientation, with
the HP logo right-side up. Mounting in other orientations may result in decreased performance under
certain conditions; operating the computer with limited power to prevent overheating is one such
condition. When the integrated fiber NIC is installed in the standard chassis and the chassis is
mounted in the horizontal orientation, the maximum ambient temperature for device operation is
reduced to 35°C (95°F).
HP t620 PLUS Thin Client: There is no orientation limitation for PLUS configurations. However,
optimal performance will be obtained in the vertical (tower) orientation.
This thin client incorporates four mounting points on the right side of the unit. These mounting points
follow the VESA (Video Electronics Standards Association) standard, which provides industry-
standard mounting interfaces for Flat Displays (FDs), such as flat-panel monitors, flat displays, and
flat TVs. The HP Quick Release connects to the VESA-standard mounting points, allowing you to
mount the thin client in a variety of orientations.
NOTE: When mounting to a thin client, use the 15 mm screws supplied with the HP Quick Release.
To use the HP Quick Release:
1. Remove four screws from the right side of the computer.
28 Chapter 2 Hardware changes