Attaching The Elite Slice G2 To A Mounting Device; Installing A Security Cable - HP Elite Slice for Meeting Rooms G2 Hardware Reference Manual

Attaching the Elite Slice G2 to a mounting device

If the VESA Plate, available as an option, is connected, the Elite Slice G2 can be attached to a table.
To mount the Elite Slice G2:
1. Connect all modules except the VESA Plate.
2. Use the four screws provided with the VESA Plate to attach the VESA Plate to a table or other surface.
3. Carefully connect the modules to the VESA Plate.
4. Slide the quick release latch on the rear of the VESA Plate to the locked position to secure the VESA Plate
to the module above it.
NOTE:
to the rear of the VESA Plate. This stops the quick release latch from being moved to the unlocked
position and prevents accidental release of the modules.
The security cable is designed to act as a deterrent, but it may not prevent the computer from being
mishandled or stolen.

Installing a security cable

The 10 mm ultra-slim cable lock displayed below can be used to secure the computer. When installed in the
bottom module, the cable locks all modules together. If the VESA Plate is installed, slide the quick release to
the locked position and install a security cable to lock all modules together.
HP highly recommends that you secure the Elite Slice G2 assembly by attaching a security cable
Attaching the Elite Slice G2 to a mounting device 11