Adjustment Item; Adjustment - Canon D1 Service Manual Digest

Basic Adjustment

Adjustment item

■ Adjustment

title
Adjusting the Shift Amount of When the front shift amount of
the paper is improper.
the Shift roller (Front)
Adjusting the Shift Amount of When the rear shift amount of
the paper is improper.
the Shift roller (Rear)
Adjusting the Front Staple When the front staple position
is displaced.
Position
2
Adjusting the Rear Staple When the rear staple position
is displaced.
Position
Adjusting the 2-Staple Position When the middle 2-staple
position is displaced.
Adjusting the Stapler Needle When the pitch between
needles for 2-stapling is
Pitch (A4)
improper.
Adjusting the switchback When the paper stack fault
occurs at the processing tray
position
by influence of the curl amount.
Punch hole position in feed When a punch hole is displaced
in the feed direction .
way
Adj of punch hole horizontal When a punch hole is displaced
in the horizontal registration
rgst pstn
direction .
2-2
Use case
Adjust the shift amount of the shift roller in the front side.
Incrementing the value by 1 moves the shift amount towards the guide
by 0.1 mm.
Adjust the shift amount of the shift roller in the rear side.
Incrementing the value by 1 moves the shift amount towards the guide
by 0.1 mm.
Adjust the paper pull amount of the gripper at the front stapling
position.
Incrementing the value by 1 increases the stapling paper pull amount
by 0.1 mm.
Adjust the paper pull amount of the gripper at the rear stapling position.
Incrementing the value by 1 increases the stapling paper pull amount
by 0.1 mm.
Adjust the paper pull amount of the gripper at the middle 2-stapling
position.
Incrementing the value by 1 increases the stapling paper pull amount
by 0.1 mm.
Adjust the pitch between needles for two stapling.
Incrementing the value by 1 widens the distance between the needles
by 0.24 mm.
Adjust the switchback position when the paper is delivered to the
processing tray.
To adjust the position of punch hole of finisher in feed direction.
As the value is changed by 1, punch hole moves by 0.1mm.
+: toward delivery side
-: toward inlet side
To adjust the punch hole in side registration direction.
As the value is increased by 1, punch hole moves by 0.45mm.
+ : toward rear
- : toward front
Details
(LV1)
SORTER>ADJUST> AMT1
(LV1)
SORTER>ADJUST> AMT2
(LV1)
SORTER>ADJUST>INSTP-F1
(LV1)
SORTER>ADJUST>INSTP-R1
(LV1)
SORTER>ADJUST>STP-2P
(LV1)
SORTER>ADJUST>STP-NTN
(LV1)
SORTER>ADJUST>CLCT-SB
(LV1)
SORTER>ADJUST>PNCH-X
(LV1)
SORTER>ADJUST>PNCH-Y
Service mode Adjustment Unit
range
-50 to 50 0.1mm
-50 to 50 0.1mm
-50 to 50 0.1mm
-50 to 50 0.1mm
-25 to 25 0.1mm
-8 to 8 0.24mm
-50 to 50 0.1mm
-50 to 50 0.1mm
-50 to 50 0.45mm
Default value
0
0
0
0
0
0
0
0
0
T-2-1