14-8. Wired remote controller (UTY-RVNYM)
DIP switch 1
¢ Switch location
¢ Dip switch setting
SW1: Memory backup setting (only for wired remote controller)
Set to "ON" to use batteries for the memory backup.
When batteries are not used, all of settings stored in memory will be deleted if there is a pow-
er failure.
SW1
OFF
ON
NOTE: Never turn it on in the case of simple remote controller.
SW2: Dual remote controller setting
Set the remote controller SW2 according to the following table.
Number of remote controller
1 (Normal)
2 (Dual)
SW1
Memory backup setting
SW2
Dual remote controller setting
Memory backup
Primary unit
SW2
OFF
OFF
Indoor unit
1 2 3
1 2 3
Primary unit
Remote controller
Invalidity
Validity
Secondary unit
SW2
—
ON
Remote controller cable
1 2 3
Secondary
unit
- 251 -
Factory setting
♦
Factory setting
♦