Sharp SB-29S Service Manual page 10

REMOVE OF FAUCET CONNECTOR AND TANK CONNECTOR
1. Remove the water partition from the tank cooler ass'y.
2. Remove the panel B-A and faucet ass'y in accordance with "REMOVE OF PANEL B-A AND FAUCET
ASS'Y".
3. Remove the side plate L-R in accordance with "REMOVE OF SIDE PLATE L-R".
4. Cut the charge tube and let compressor's coolant out off the compressor about 1 minute.
5. Blow gas 2 joints, and remove the cooling coil from the compressor, the capillary tube from the filter
driers.
6. Remove the adhesive foam tape from the faucet connector and the tank connector.
7. Cut 2 cord bands holding the hot water inlet tube and cool water outlet tube.
8. Remove the faucet ass'y (Cool water) and remove 3 screws holding the heater tank ass'y.
9. Remove the thermostat ass'y from tank cooler ass'y.
10. Remove the insulation foam from the tank cooler ass'y.
11. Remove 2 mounting nuts by toolbox and detach the faucet connector and tank connector from tank cooler
ass'y.
12. Now the faucet connector and tank connector are free.
Note : Recheck the Hot & Cold water dispenser for water leaks, after replace or repair the faucet connector
parts and tank connector.
Capillary tube
Cooling coil
Joint
1
Tank connector
Toolbox
Filter driers
Joint 2
Compressor
Cool water outlet tube
Cord band
Heater tank ass'y
Fig. 10
10
Water partition
Faucet connector
Bellow cap
packing
Tank cooler ass'y
Cooling coil
Mounting nut
Insulation foam
Tank support
Cord band
Hot water inlet tube
Screw