Using Telnet To Connect To Nokia Ip40 Security Platform - Nokia IP40 User Manual

4
Accessing Nokia IP40 Security Platform
The IP40 ships without a password defined. If you are logging in for the first time, you are
prompted to define the password by entering it twice. If you logged in before, enter the
username and password you previously defined.
For more information about CLI commands, see Nokia IP40 Security Platform CLI Reference
Guide, Version 2.0.

Using Telnet to Connect to Nokia IP40 Security Platform

You can access the command-line interface of Nokia IP40 Security Platform through a Telnet
session.
Telnet access is disabled by default. You can allow Telnet access from the LAN, and WAN by
configuring separate user rules. (No LAN or WAN access is available until it is configured)
Note
Before you start Telnet, ensure that the Telnet program is installed on your computer, and
that you can access IP40 by using Telnet. The method for starting Telnet differs between
operating systems. You can use the method given here to start a Telnet session from
Windows 2000.
To connect to IP40 Security Platform by using Telnet
1. Choose Start > Run
2. In the command window that appears, type telnet followed by the IP address of your IP40
security platform.
If your device IP address is 192.168.10.1, the run window opens as follows:
3. Click OK.
The Telnet command window opens with a login prompt.
68 Nokia IP40 Security Platform User's Guide v2.0