Makita DLS714 Instruction Manual page 14

To remove the blade, perform the following steps:
1. Lock the handle in the raised position by pushing
in the stopper pin.
1.
2.
holding the center cover by turning it counterclockwise.
Then, raise the blade guard and center cover.
2
3
1. Center cover 2. Hex socket bolt 3. Hex wrench
4. Blade guard
3.
wrench to loosen the hex socket bolt clockwise. Then remove
1. 2. Hex socket bolt 3.
4.
dle with its blade mounting part facing the blade. If the
the machine.
1
1
4
1
3
2
1
4
1.
socket bolt (left-handed) 5.
ing part
To install the blade, perform the following steps:
1.
Make sure that the direction of the arrow on the blade
matches the direction of the arrow on the blade case.
2
1.
2.
then use the hex wrench to tighten the hex socket bolt
(left-handed) of the spindle securely counterclockwise
while pressing the shaft lock.
3. Return the blade guard and center cover to its
original position. Then tighten the hex socket bolt of the
center cover clockwise to secure the center cover.
4. Release the handle from the raised position by
pulling the stopper pin. Lower the handle to make sure
that the blade guard moves properly.
5. Make sure the shaft lock has released spindle
before making cut.
15.88 mm hole-diameter saw blade
outward onto the mounting shaft and then place saw
-
and hex bolt.
14 ENGLISH
2
6
2. 3.
6. Blade mount-
2
2.
3
5
4. Hex
1