Installing Web Pdi - LG PQCPM11A0 Installation And Owner's Manual

2. Installing Web PDI

This chapter describes how to install the Web PDI to use.
Caution: Installing the Web PDI
The Web PDI installation work needs the professional technique. Therefore, the
installation described at this chapter should be performed by the certified
installation professional.
Consult the service center or the professional installation agency certified by us about
any question or request related to the installation.
Before Installation :
1. Web PDI must be installed with PDI.
2. The central controller must be one of three (ACP, BACnet, BNU-LW)
In order to use the Web PDI, the installation should be performed by the following order.
STEP 1. Check whether the central controller such as BNU-LW or
BACnet is working well before attaching Web PDI.
STEP 2. Connect TX line to the '+' of CN_PC and RX line to the '-'
of CN_PC on the PDI's PCB.
STEP 3. Configure the IP and G/W address of Web PDI
STEP 4. Configure the SETTING(in/out door address) on the web
site of Web PDI.
STEP 5. Verify whether the value of PDI and the value on the
website of Web-PDI are identical or not.
2. Installing Web PDI
Installation/Owner's Manual
2-1