Operation section
Once the settings have been configured, all you need to do is push the
12
2
5
3
1
button (Fan speed select button)
No function.
2
button (Timer set button)
Use to setup the timer.
3
button (TEST button)
Use only for service.
(During normal operation, do not use this button.)
4
button
No function.
5
button (Filter reset button)
No function.
6
button (Power save operation)
No function.
7
SWING/FIX
button
No function.
8
Operation lamp
Lights up during running.
Blinks when an error occurs or the protective
device activates.
9
button
Turns on the unit when pushed, and turns off when
pushed again.
10
button (Operation mode select button)
Heating mode is only available. Only heating
symbol is displayed.
13-EN
button from then on.
1 8
9
10
4
11
7
6
11
UNIT LOUVER
button (Unit / Louver select button)
UNIT button:
No function.
LOUVER button:
No function.
12
button
Adjusts the set temperature.
Select the desired set point by pushing
or
TEMP.
OPTION:
Remote controller sensor
Do not use "Remote controller sensor".
– 7 –
4
Basic operation
When you use the hot water module for the first time or change the settings, follow the procedures below.
From next time, pushing the
Preparation
Turn on the power switch
• When turned on, the separation line appears and
* The remote controller will not work for about 1 minute after turning on the power. This is not a
malfunction.
REQUIREMENT
• Keep the power switch turned on during use.
• When you resume using the hot water module after a long period of disuse, turn on the power switch at least
12 hours before starting running.
Operations
TEMP.
TEMP.
TIMER SET
FAN
TIME
SAVE
FILTER
RESET
TEST
SET
CL
SWING/FIX
1
Push the
button.
The operation lamp lights up.
2
Push the "MODE
operation mode.
Only heating symbol is displayed. Heating mode is
only available.
Heating
3
Push the
button to stop running.
The operation lamp turns off.
button starts running of the hot water module with the chosen settings.
blinks on the remote controller display.
Changing the set temperature
1
Push the "TEMP.
Push
to increase the temperature, and
decrease the temperature.
Operation mode
Setting range
ON / OFF
1
HEAT
2
MODE
VENT
UNIT LOUVER
" button to select a
" buttons.
to
Factory default
25 to 50 °C
35 °C
14-EN