Fujitsu ARROWS NX F-01K Instruction Manual page 203

Bluetooth Version
Output
Supported
*12
profile
Earphone/microphone jack φ3.5 mm earphone jack,
Display language
Input language (Character
entry)
Input language (Voice
input)
*1
It is not the actual storage capacity because the memory is also
used for the Android OS and preinstalled applications.
For available memory, see "Storage" →P144
*2 Continuous stand-by time indicates the estimated stand-by time
when radio signal reception is normal. Stationary continuous stand-
by time indicates the estimated average operation time when radio
signal reception is normal.
Due to internal battery charging condition, function settings,
operating environment such as ambient temperature, radio wave
conditions in the area of use (the radio waves are weak or absent),
etc. stand-by time may be reduced to about half.
*3
Activating applications also reduces call (communication)/stand-by
time even if you do not call or use the Internet.
*11
5.0
BT5.0 BR/EDR：Power Class 1
BT5.0 LE : Power Class2
*13
HFP (1.6) , HSP (1.2),
OPP (1.2), SPP (1.2),
*14
HID (1.0), A2DP (1.2) , AVRCP
*15
(1.5), PBAP (1.2), PAN (1.0)
HDP (1.0), ANP (1.0), FMP (1.0),
PASP (1.0), PXP (1.0),
TIP (1.0), HOGP (1.0)
tetrapolar
Japanese/English
Japanese/English
Subjected to Google voice
search function
*4 Continuous call time indicates the estimated time that the phone
can send or receive radio waves normally.
*5
Continuous 1Seg/Full Seg watching time indicates the estimated
watching time when radio signal reception is normal.
*6
Charging time indicates the estimated time for firstly charging an
empty internal battery with the terminal turned OFF for
approximately 10 minutes, and then charging with the terminal
,
turned ON. When the temperature is high or low, it takes a long
time for charging.
*7 Setting can be made in RapidPic mode only.
*8
When temperature of the terminal is raised during using, the
camera operation may be ended.
*9
2.4 GHz/5 GHz are supported for IEEE 802.11n.
*10 IEEE802.11n/ac supports MIMO.
*11 It is confirmed that the terminal and all Bluetooth devices are
compliant with Bluetooth standards designated by Bluetooth SIG,
and they are authenticated. However, procedures may differ or
data transfer may not be possible depending on the device's
characteristics or specifications.
*12 These are created by standardizing connection procedures for
Bluetooth communications according to individual product
properties.
*13 It supports mSBC (16kHz) and CVSD.
*14 The terminal supports aptX, aptX HD and SBC audio codecs.
*15 The terminal supports PAN-NAP and PANU.
■Internal battery
Battery used
Nominal voltage
Nominal capacity
201
Li-ion battery
3.80V
2580mAh
Appendix/Index