Settings - Husqvarna AUTOMOWER 440 Operator's Manual

isolated using the boundary loop, operational safety can
be improved by carrying out some of the manual
settings outlined below.
3.17.5.2 Corridor width > Boundary
The boundary corridor width is specified in intervals from
1-9. The first number in the interval specifies the
shortest distance to the boundary loop and the second
number the longest distance.
The distance the robotic lawnmower maintains from the
boundary loop varies depending on the layout of the
working area.
Use the number keys to specify the required interval.
The factory setting is 3-6.
3.17.5.3 Corridor width > Guide
The guide corridor width is adjusted automatically. Only
in rare occasions manual settings need to be entered.
The guide corridor width can be set between
0 is specified, the robotic lawnmower will
If value
straddle the guide wire meaning it runs right over the
middle of the guide wire.
Use the arrow keys to specify the required value.
9 .
The factory setting is
3.17.5.4 Exit angles
Normally the robotic lawnmower leaves the charging
station in a direction within the 90°-270° exit sector. By
changing the exit angles, it makes it easier for the
robotic lawnmower to reach the largest working area if
the charging station is placed in a passage.
3.17.5.5 Exit angles > Sectors
The robotic lawnmower can be set for 1 or 2 exit
sectors. If the charging station is placed in a passage, 2
exit angles, for instance 70° - 110° and 250° - 290°, can
be used.
32 - Installation
When 2 exit angles are used, there is a need to also
specify how often the robotic lawnmower must leave the
charging station in
Proportion function by initially specifying a percentage.
For instance the percentage of 75 % means that the
robotic lawnmower leaves the charging station in
1 on 75% of the times and 25% of the times in Sector 2 .
Use the number keys to specify the required angles in
degrees for the sectors and proportion as a percentage.
3.17.5.6 Reversing distance
This functions allows you to control how far the robotic
lawnmower has to reverse out from the charging station
before it starts mowing. This is a useful function for
instance if the charging station is placed way in under a
veranda or in another limited space area.
Use the number keys to specify the required reverse
distance in centimetres. The factory setting is 60 cm / 24
in.
0 and 9 .
3.17.5.7 Drive past wire
The front of the robotic lawnmower always passes the
boundary wire by a specific distance before the mower
turns around. The default distance is 31 cm / 12 in. but
this can be changed if required. A figure between 20 and
50 can be selected.
Note that the distance given is only an approximate
value and should be regarded as a guide. In reality, the
actual distance the robotic mower passes the boundary
wire can vary.
Specify the number of centimetres you want the robotic
lawnmower to pass the boundary wire and press OK.

3.18 Settings

This selection allows you to carry out changes to the
robotic lawnmower's general settings.
Sector 1 . This is done using the
Sector
447 - 001 -