HP 9000 Installation Manual page 47

D class and r class i/o card installation

Hide thumbs Also See for 9000:

M. Replace the Top

1. Position the hinge tab of the top rear panel so that it goes into the slot at the rear

Covers

2. Position the hinge tab of the top front panel so that it goes into the slot at the

3. Align and tighten the three screws of the top front panel into the holes as shown

N. Replace the

1. Align the control panel bezel over the power switch and LCD display and push

Front Bezel

CAUTION

Until the LCD and power switch bezel is attached, the area surrounding the LCD is

ESD sensitive. See "Electrostatic Discharge Precautions" on page 2-2.

2. Align the front bezel over the front of the chassis and push gently to secure the

O. Refer to I/O

Refer to the documentation accompanying the I/O card for information regarding

Card-specific

external connections.

documents

This completes the I/O card installation procedure. Proceed to the I/O Card

Installation Verification procedure starting on the next page.

of the system cabinet. Lower the top rear panel into place.

front of the system cabinet. Lower the top front panel into place.

in the illustration.

gently to secure the bezel in place..

bezel in place.

R Class I/O Card Installation

I/O Card Installation Procedure

2-15