Directives - Siemens SINAMICS G130 Operating Instructions Manual

General

2.2 Directives

NOTICE
Only use original Siemens accessories
To ensure that the entire system functions properly, you are advised to use the original
Siemens accessories.
Only original DRIVE-CLiQ cables may be used for wiring the DRIVE-CLiQ nodes.
Before commissioning, check the tightening torque of all the terminal screws.
Potentially fatal touch voltage
Cable shields and unused conductors of power cables must be connected to PE potential.
Hazardous voltages can occur if this is not observed.
NOTICE
Limitation of overvoltages
On ungrounded systems and systems with a grounded phase conductor and a line voltage
>600 V AC, measures must be taken on the line side to limit overvoltages to overvoltage
category II in accordance with IEC 61800-5-1.
2.2 Directives
The switchgear cabinet must satisfy the following EC Directives in the European Economic
Area (EEA):
Table 2- 1 Directives
Guideline
2006/95/EC
2004/108/EC
10
WARNING
Description
Directive of the European Parliament and Council of December 12, 2006, on the approximation
of the laws of the member states relating to electrical equipment designed for use within certain
voltage limits (Low-Voltage Directive)
Directive of the European Parliament and Council of December 15, 2004, which repeals directive
89/336/EEC, on the approximation of laws of the member states relating to electromagnetic
compatibility (EMC Directive)
Cabinet design and EMC
Operating Instructions, 03/2013, A5E00427629A