4. Press both clips simultaneously toward each other and pull the conversion bracket out of the rear of the
kit.
Figure 46. Removing the conversion bracket from the kit
5. To remove the 2.5-inch storage drive, flex both sides of the conversion bracket and then remove the
drive out of the bracket. Do not touch the circuit board on the drive.
Figure 47. Removing the 2.5-inch storage drive from the bracket
6. To install a 2.5-inch storage drive, ensure that the conversion bracket is folded. To fold the bracket, do
the following:
a. Remove pins
1
Figure 48. Removing pins and reinstalling them into new slots
122
P720 Hardware Maintenance Manual
and reinstall them into slots
2
.