ABB i-bus KNX Product Manual page 77


ABB i-bus KNX
Commissioning
With the option yes: via object "Brightness value/status", the following parameter appears:
Status response of lamp/ballast fault
Options:
This parameter defines how the current status of a lamp/ballast fault is sent.

yes: A status message is sent. The sending behavior can be set using the following Send parameter

no: No status message is sent and no communication object is displayed.
With option yes, the following parameters appear:
Send
Options: after a change
after request
after a change or request

after a change: The status is sent via the communication object after a change.

after request: The status is sent after a request by the communication object Request status
values.

after a change or request: The status is sent via the KNX when the status changes or the
status is requested via the communication object Request status values.
yes
no
Send
Options: after a change
after request
after a change or request

after a change: The status is sent via the communication object after a change.

after request: The status is sent after a request by the communication object Request status
values.

after a change or request: The status is sent via the KNX when the status changes or the
status is requested via the communication object Request status values.
DLR/A 4.8.1.1 | 2CDC507128D0202 75