Kenwood NX-700 Instruction Manual page 6

OPERATING BASICSA
Switching Power ON/OFF
Press the switch to switch the transceiver ON.
Press and hold the switch for approximately 1 second to switch the transceiver OFF.
Adjusting the Volume
The Volume Up/Down SW control to adjust the volume. You can adjust the volume up sw to increases the volume and
the volume down sw to decreases it.
Selecting a Channel
The Channel Up/Down SW to select a channel.
The channel up sw the channel number increases and The channel down sw decreases it.
Transmitting
Note: Before transmitting, first monitor the channel to make sure it is not already in use.
1 Select your desired channel.
• If the channel is busy, wait until it becomes free.
1 Press the microphone PTT switch and speak into the microphone. Release
the PTT switch when you have finished speaking.
• For best sound quality at the receiving station, hold the microphone approximately 1.5 inches (3~4cm) from
your mouth.
Receiving
1 Select your desired channel.
2 When you hear a signal, readjust the volume level if necessary.
2 Respond to the call as described in step 2 of "TRANSMITTING",above.
AUXILIARY FEATURES
Time-out Timer (TOT)
The purpose of the Time-out Timer is to prevent any caller from using a channel for an extended period of time. If you
continuously transmit for a period of time that exceeds the programmed time, the transceiver will stop transmitting and
an alert tone will sound. To stop the tone, release the PTT switch.
Your dealer can program a warning function to alert you before the TOT expires. Continuously transmitting for the
specified by your dealer will cause the warning tone to sound.
TING
NX-700-K FCC ID: K44378600 / IC: 282F-378600
NX-800-K FCC ID: K44378700