Auto Code Search - GE 34455 Instruction Manual

Programming Your Remote

Auto Code Search

The Auto Code Search is a process where you can
search through all the codes stored in the remote to
strm
find a code for your device. It is recommended that
you read through all the steps below to familiarize
yourself with the Auto Code Search before starting
the process.
1. Manually turn on the device you wish
2. Press and hold down the SETUP button
3. Press and release the device button on
strm
4. With the remote pointed at the device,
Did the device turn off?
strm
5. Manually turn the device back on.
strm
6. With the remote pointed at the device,
input
to control.
Note: The Auto Code Search process cannot be
used for devices without power ON/OFF capability.
Use the Direct Code Entry method in these cases.
on the remote until the red light on the
ch
remote control turns on. Release the
SETUP button. The red light will
remain on.
Note: The red light will either be a small light at the
top of the remote or the power ON/OFF button.
the remote for the type of device you
wish to control, for example tv, dvd, cbl,
strm. The red light will blink once and
remain on.
input
press and release the POWER button
on the remote. The remote will send 10
different codes to the device. The red
light will blink once for each code and
remain on after sending the 10 codes.
input
• If YES, go to Step 5.
enter
• If NO, repeat Step 4 to test the next
10 codes.
ch
input
press and release the VOL + button. The
remote will re-send the first code of the
10 codes from Step 4. The red light will
blink once and remain on.
8
ch