NetCam_ii_99011_0047.qxd
NetCam4
Enter the new IP address and confirm it with the 'OK' button.
I
If NetCam4 has a problem, you can reboot by
I
clicking "Reboot".
2.4
Configuring NetCam4
After assigning a new IP address to the NetCam4, you
I
may configure the administrator's options. Click 'Start
Configuration' button, and you will be connected to the Administrator
pages in the NetCam (see Chapter 4).
2.4.1
Fast Configuration
If you want another NetCam4 with the same setup,
I
you can use 'Fast Configuration'.
Using the 'Load' button, you can use the saved
I
configuration of another NetCam4. However, some
information such as; 'Serial Number', 'Date & Time'
and 'IP configurations' need to be setup independantly. You should
configure 'Date & Time' and ' IP Configuration' again with setup program.
'Serial Number' cannot be changed.
To save:
After setup, close NetCam4 homepage.
Click 'Save' button.
I
Save the information (select a suitable directory and file name).
I
To Load:
Select the directory and file name of the saved NetCam 4.
I
Click the 'open' button and click 'ok' to confirm.
I
12/13/00
1:55 PM
Page 13
Section 2
13