Initialization - Panasonic EA-7HW02AP1 User Manual

3.5. Initialization

It is possible to initialize (reset the setting data and the log data to the default) the wireless unit directly without using
the initialization command.
1. Hold down the INIT switch using something that has a needle-like tip such as a skewer.
* Start working after removing static electricity.
2. Connect the AC adapter and the PoE injector, and then turn on the power.
3. Wait until the ACT LED starts blinking red.
4. When the ACT LED blinking red turns to blinking green, release the INIT switch.
Network interface
Wi-Fi interface (2.4G)
Wi-Fi interface (5G)
Ethernet1 (ETH1)
Ethernet2 (ETH2)
Default of each interface after the initialization
Default
Off Default after validating the interface
2412MHz, HT40
Off Default after validating the interface
5180MHz, HT80
- Default fixed IP (192.168.0.3/24)
(Access will become available after approx. 90 seconds from the
start-up.)
- Default fixed IP (192.168.0.3/24)
(Access will become available after approx. 90 seconds from the
start-up.)
Remarks
53