Advertisement
References for Installation
Powering On an RTN 360
•After unpacking an RTN 360, power it on within 24 hours.
•Do not power off an RTN 360 for more than 24 hours during maintenance.
Dock
To the
RTN 360
To the opposite
wireless equipment
External power
supply equipment
If one Dock supplies power to only one RTN 360, connect the outdoor network cable that
connects to port P&E on the RTN 360 to port WAN on the Dock.
When an RTN 360 is running properly, its indicators should be in the following states:
STAT: is steady green.
18/19 >>
•Ensure that the Dock is powered on and works properly.
•On an RTN 360, only port P&E supports power over Ethernet.
RTN 360
Use clips to fix any indoor sections of the outdoor network
cables that connect to ports WAN, LAN0, and LAN1 on the
Dock, and remove the plugs in the cable trough.
Clip
Opposite wireless equipment
RTN 360
RTN 360
External power
supply equipment
If one Dock supplies power to two RTN 360s, connect the outdoor network cable that connects to
port P&E on one RTN 360 to port WAN on the Dock, and the outdoor network cable that
connects to port P&E on the other RTN 360 to port LAN1 on the Dock.
Port WAN, which is connected to one RTN 360
Port LAN0, which is connected to the
opposite wireless equipment
Port LAN1, which is connected to the
other RTN 360
Opposite wireless equipment
Dock
Advertisement
