Panasonic KX-TD816 Installation Quick Manual page 12

d)
Press
• The result is recorded.
Display: STORED
Note
• To return to the previous display, press
• If a channel is set, the results of measurement for the 24 slots on the channel are saved each
time. If the same channel is set, the new results override the previous ones. Therefore, a
measurement of 10 channels
• If correct results cannot be obtained (e.g. there are many error counters), change the
allocation of the Cell Station and repeat the site survey to select the best location.
• When a slot is synchronised in step 2, "SYNC" is displayed.
• Please do not use several PSs for the test simultaneously. This may cause interference
problems, so that the test may not executed properly.
Referring to the recorded Radio Signal Test result
1.
Keep pressing
Display: FUNCTION (0-4)?
2.
Press
• When the Scan Data is not recorded, the display will show "NO SCAN DATA" and
then return to the initial display.
• When the Radio Signal Test result is recorded, the display will show as below.
Display example: RESULT OF SCAN
3.
Enter the desired log number (0 through 9).
Display example: RESULT OF SCAN
4.
Press
• The results of channel 0 and slot 0 will be displayed.
Display example: CH0 SLOT:00 SYNC
• To go to another slot, scroll by pressing
To go to another channel, enter the channel number (0 through 9).
12
.
24 slots in total can be made.
, and
.
LOG NO.(0-9)?
0
LOG NO.(0-9)?
0
.
L:12
CS-ID:9005301234
.
until following message will be displayed.
0
0000/0100
(Previous) or (Next).